Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate the current carrying capacity of cable
- 2 Answers
- 6673 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / sandeshg
by using wire gauge calculate the size of the conductor and
number of the conductors and finally see the data sheets of
conductor size sheets
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Define resonant peak?
what is the formula of starting current of 3phase and 1 phase motor???
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
how you taken aotitude test
hi frnds what is meant by harmonics & what is meant by third hormonics,where its will occur ?thank u
Q) Write VBscript code along with QTPscript code in QTP tool for below scenario 1. Launch yahoo site(i know) 2. Do loogin(i know) 3.Click inbox link(i know) 4.Go to every page of mail box and count no.of read mails and no.of unread mails(i know) 5.Store page numbers, read mail count and unread mail count in a new excel file sheet 6.Create 10 types of graphs on that data 7.Do logout and close site(i know) 8.Save new excel files with graph
What is difference between unity power factor wattmeter and upper power factor wattmeter? In short circuit test of transformer the wattmeter used is unity power factor type or upper power factor type wattmeter?
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
How much minimum insulation required between 11kv/3.3kv transformer windings?
what is the difference betweem star connected motor & delta connected motor?
List few applications of d.c series motor?
In radial network the source is fed from 1 end both ends at central
to vary valtage from 0 - max a variac is necessary . so how to design for high power applications nearly about 200KW power
