An op-amp comparator circuit uses which of the following
a. positive feedback
b. negative feedback
c. active feedback
d. no feedback
- 4 Answers
- 4182 Views
- I also Faced
- E-Mail Answers
Post New Answer View All Answers
What is transistor biasing?
What type of gating signal is used in single phase ac voltage controller with rl load?
In connections of mcb, is it necessary that the incoming side supply should be connected at top side of mcb. Whether this has any effect in tripping of mcb in case of fault?
What are the different methods to turn on the thyristor?
Tell me something about IN call Flow and what is the difference between the flows in both GSM and CDMA technologies?
What is the approximate cost of the monitoring cables time domain reflectometry?
Types of (Open Shortest Path First) Link State Advertisements (LSAs)?
please send me last five year papers for my electronic and communication branch as i have completed my graduation in diploma.
What is the work of Bus cable, Power cable and Er cable in nokia flexi edge bts.
What is meant by bidirectional or half-wave ac voltage controller?
What is the state if the RED LED is glowing on DVxx card What is the state if the YELLOW LED is glowing on DVxx card What is the state if the GREEN LED is glowing on DVxx card Which frequency band DVDC is used Which frequency band DVGA is used
On what parameters does the free running frequency of vco depend on?
temperature transmitter range o to 100c over range set value 21.6ma if you give source on the field transmitter showing iop out put also 21.6ma but dcs not showing iop samething if you simulat from hart 21.6ma in dcs showing iop how its possible?
What is meant by soa?
What is used for high speed reading and storing of information in a computer?
