Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sanjeet
because it depands on how much current it can
discharge(previously stored) averagely in an hour i.e how
long it can give the back up to the load it is connected.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
'documenˁ
What are the types of the glands and difference between single and double compression type of cable Glands.
What are approaches to tackle sedimentation problem of reservoir?
Whats the minimum value for I.R. that can be allowed for HT & LT alternators for operation?
WHAT IS SUBSTATION & ACCORDING TO VOLTAGE HT,EHT SUBSTATION EXPLAIN IT
What is the effect on 3phase induction motor if current setting knob of DOL kept at minimum current?
What is thresh hold value of current?
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
Why there are some equipment(i.e:TV) that using 2-pin plug instead of three? What happen if there is current leakage? Are we going to get electric shock??
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?
how we can do the insulation on secondary of ct explain and so that tan delta will within limit
What is the two pole structure?
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
