Answer Posted / sandeep mathur

because of form factor factor
form factor= average value of emf/rms value of emf

which is equal to 1.11

WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?

4386

---

When and where resistance earthing is used ? How to calculate the time constant for earth fault

1815

---

When we use 3 terminal resistor?

1245

---

What are the advantages and disadvantages of the dc motors?

1133

---

Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?

3040

---

how to calculate kvar in Akiva

1937

---

two phases with neutral supply can be taken in 3C X 10 sq.mm cable .

1425

---

How can calculate the rating of a alternator for a given specific load with formula

2342

---

what are the condition that makes hooter blow?

2446

---

A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .

2635

---

armature winding of dc machine produce alternating emf then it convert in to dc by using commutator.But only we consider armature resistance why don't we consider inductive reactane effect?

2067

---

How you calculate the repturing capacity of a HRC fuse

2619

---

What happen Grid EARTH plat got cut.

2223

---

What is slip in an induction motor?

1156

---

In Generator How suction compression power and exhaust works ?

1946

---