Which of the following instruments consumes maximum power
during measurement?
- 3 Answers
- 10660 Views
- I also Faced
- E-Mail Answers
Answer Posted / dinesh
electrodynamometer
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows
Q- What are the application in which PNP transistor is preferred over NPN ?
Why MUX JB's are using only Temperature Element in Fundation field bus?
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264
principle of dead weight tester ?
what is the usage of QDV & VOLUME BOOSTER
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
how to measure oxygen which methods are using?
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
Why flow/pressure transmitter before control valve?
