Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate current carrying capacity in power cable?
- 1 Answers
- 5506 Views
- I also Faced
- E-Mail Answers
Answer Posted / 7anoter4
It depends on many factors:
For continue load:
insulation maximum permissible temperature: pvc-70 dgr.C
XLPE,EPR-90 dgr.C
conductor material-copper or aluminum
cable routing: open air, in conduit, cable tray, underground
[buried, ducts] and so on.
ambient temperature: air[30-40 dgr.C], earth [20-25]
thermal resistance of the earth
other[like shield losses, conduit losses and other]
In the IEC World IEC 60287 could be a guide.
In USA the J.H.Neher and M.H.McGrath publication could be a
guide:
"The Calculation of the Temperature Rise and Load
Capability of Cable Systems"
For short-time[as in short-circuit case]it depends on
insulation maximum permissible temperature[140 pvc, 250
xlpe,epr] ,conductor material and the duration of the load.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
how can get electrical "c" licence.i am complited in DEEE.PASSING YEAR OF 1993.WORKING IN PVT COCERN LT LINE.PLEASE ADVISE ME .CELL NO 9994786021
hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
why dc is used in control circuit for mv & hv switchgear instead of ac
What is the maximum percentage voltage drop (vd%)for a motor control center
what is ramping rate of generator
WHY THE COLOR OF OUTDOOR TRANSFORMER IS BLUE ONLY???
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
Why earthing is necessary for any equipment?
what is meant by 2 within a star in a voltmeter dial?
What is electrical diversity factor in electrical installations?
what is meant by the phrase 'static load' in case of shorting in a generator excitation system?
What does quality factor depend on in resonance?
what is relay what is protection & contact multiplying relays where it is used function in brief
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
