Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bala murali/ramesh
CAL Mode used in instrument/sensor/transmitter maintenance/repair/calibration time.In that time we can give some reference value which is for normal control operation.
Calibration means sensor/transmitter response calibration for required range.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much
what is natural frequency of turbine shaft .
what does mean by kva rating
what's the moog valve
Which will have more strain energy 1.Spring 2.Circular disc 3.Solid square plate.
what is restricted earth fault explain in details
Why superheated are started before I'd and rd fan?
why do you consider yourself a suitable candidate for this position
what is the meaning of SST300 V56A in SIEMENS turbine
why airtel use + 24 volts and other operators use -48 volt
What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?
why is the in steam turbine axial displacement of active side thrust pad is positive and non active side thrust pad is negative.
By any way can we increase the B check hours from 300 to 500
our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
