What is the Laplenth for Reinforcement for Verticl and
horizontal Structures as per IS code?
- 7 Answers
- 11226 Views
- I also Faced
- E-Mail Answers
Answer Posted / kj
Vertical is a commpression member like coloumns etc and horizontal is a bending member.Depending on grade lap length will be determined.Horizontal will be more allways as bending stress.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
How to calculate Volume of Wet cement concrete for a specific grade?
For removal of formwork of simply supported slab / beam from where to start the deshuttering? ( Max Bending moment of the simply supported beam is in the center hence is it required to start from the supports?)
Technical Question of Civil Engineering
What things architect have to take care of before starting any project?
How much does the leaning tower of pisa lean?
how much shouid be the rate for ready mix concrete per cubic meter
RR masonry rate analysis
What is unit weight of normal concrete?
What are the responsibilities of a site manager?
HOW SOON CAN YOU TRAVEL DON TO ANY LOCATION POSTED U?
How much Tolerance factors like 1. brick work 2.plaster 3.painting 4.floor tiling 5.wall tiling 6.shuttering 7.concreting 8.steel
Which prize is the alternative to the NOVEL Prize?
how many litres of enamel paint required for 5000 sft of site??
when it is noted "JAMB SIM" what is the term "SIM" and what does it mean?
could u tell me how to used deform stell bar in reinforce concret?i wanna know the general using in the site!
