Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / yogesh more (ysm)
The solid earthing means a direct connection of neutral to earth when the voltage of a heavy phase in the event of a line to ground fault does not rise beyond 80% of the line voltage, solid earthing is recommended.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
If a 3 phase induction motor is in off condition in the conveyor and rotor of the motor keeps moving with the conveyor than the resistance of windings of motor varies. why is it so ??
the problem faced on star or delta winding connection??
Briefly describe your ideal job?
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
how to decide no of electrodes for 1600A LT Main incomer panel
How generator NPS(NEGATIVE PHASE SEQUENCE TEST)TEST WAS DONE? PROCEDURE WITH DETAILS?
sir iam from electrical and electronics branch ,can i appear for the hpcl offline requirtment? if yes please mail me on vikram_raju25@yahoo.co.in
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
What is electrical cable termination
Please explain, how to test vector group of tranformer(Delta y1) . Thank
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
What is the real function of reverse power relay in generator panel while syncronising?
In AC if the direction of current keeps reversing every half cycle, how does it propogate through the transmission lines?
why co incidence factor considered in transformer sizing?
what curve and rateing would you use for a three phase 0.75kw motor?
