Answer Posted / debashis das
the function of MCCB is used for over load thermal
protection,it make the ckt normal condition and break et
fault condition.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
Where should the lighting arrestor be placed in distribution lines?
Which type of DG need Netral Earthing?
what are the basic insulation levels & what its Unit
whatare the disadvantages occur,if the form factor of transmission will not be equal to 1.11
what is the difference between megger and earth resister ??
i have some screw comprressor with 630kw power,i have established them with simple star to delta circuit,by the way there is so much inertia when the screw comprressors start, can you offer me contactors power with 400vac or any cataluge to choose the contactors
Tell me all plants load factors i.e which plant operating on which load?
mention hazard experienced during installation
What Is HO factor in power selection
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
why Lightening Arrester Probe sharp at Top of telecom tower.
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?
