how to creat mix m-20? and how to check shuttering & how is
mark layout at open ground
- 1 Answers
- 3761 Views
- I also Faced
- E-Mail Answers
Answer Posted / ratheesh
M20 = 1:1.5:3
shuttering
1. Slab & beam bottom level should be checked.
2. All props and bracing pipes should be checked,
3. Beam & Slab side alignment should be checked
4. side shuttering plump should be checked,
5. All room dimensions & Openings dimensions should be checked
6. before reinforcement should be apply shuttering oil.
Layout
you should be use pythagoras theorem...
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the coeffiencent Friction Angle between Steel and Ashphalt?
how to conversation of all construction material in to brass
brickwork labour rate per cum ?
The internal dimensions of a wire house 15m*5.6m and the maximum height of piles is 2.70m. What is the maximum number of bags to be stored in two piles ?
How much cements bag (or in KG) required for 1 Sq. M concrete, for M-30 grad concrete as per CPWD and where is thr proof on site
Define What is made from large rocks, which protects the base of cliffs?
what is the design procedure for building
Design a reinforced concrete combined footing (rectangular) for two columns located 3.60 metres apart. The overall sizes of the columns are 40cm x 40cm and 69cm x 60cm and the loads on them are 1000 kn and 1500 kn respectively. The space available for the width of the footing is restricted to 180cm. The S.B.C. of the soil is 280 kn/mm2 use M15 concrete.
how do you calculate the quantity of steel,cement for plinth beam. (example size 41'*0.58'*1.08')
. Write a C program to perform following functions:- a. Declare one integer variable of all the storage classes. b. Print all the variables without assigning any values in tabular format. a. The tabular format must contain the variable name, type, storage class and printed value on the screen in RED color.
what is the use in canals of longitudinal drains and cross drains in lining areas?
types of laps in column
What are the different softwares used for cad?
Minimum concrete cover in slabs, columns, beams, foundation and other st?
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
