what effect on electrical equipment if PF is gone over 0.996
in leading when provider say that its keep in minimum
0.996lagging
- 3 Answers
- 6092 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / subbarayalu
Leading power factor results in higher receiving end voltage, which again results in increased power loss in Transformers & Cables same as lagging power factor.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
What is the difference between a fuse and a breaker?
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
Difference between shunt, PMG and AREP excitation. Which is the most reliable between PMG and AREP.
DG cranking voltage?
sir please send me techinical questions for junior engineer posting in bangalore railway i am diploma holder
1.what is the funtion of chiller primary & scondary pumps. 2.what is the use of distribution lines & Types. 3.what is the use the thermal power stations & how much capacity.
Iwould like to know barc interview questions
Hi, This is Laila. I am selected for syndicate bank interview. Could you please share your views and the questions asked if you have faced the interview My email id is laila_honey09@yahoo.com Please send as fast as u can.Thank You Thanks... Laila.
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?
There is any especial requirement for motor to drive through with VFD?
which protection function should measure RMS value of current&DFT value of current?
Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m
PLS SEND THE RRB CHENNAI MODEL QUESTION PAPER my email id is ganesan98655@rediffmail.com
