We have 132KV/11KV Grid connected power transformer for
getting power from Grid. Can we use this transformer for
sending generated power as well. I mean step up from 11KV to
132KV and transmit.
Answer Posted / avnish kumar
yes we can use the said transformer to step up the power. i.e if we used a 132Kv/11KV 5Mva transformer thus we can received the power cap. 5Mva at 11Kv level, but in case of step up i.e 11Kv/132Kv the generation point is 11Kv in this case the firs generation point i.e 132Kv generation capacity should be less than the capacity generated by the 11Kv generator. but over all capacity should not be more than the capacity of transformer.
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is the trip circuit supervision in an electrical meaning?
How to calculate boiler capacity? I have 1 Autoclave, Which has to use for AAC block. Dimension for this Autoclave is - 13 Meter Length & 2.2 Meter Diameter.
can u please tell me how to calculate the concrete quantity for a under reamed pile? r=300mm,depth=3m for a cylinder and for bulb l=.750mm,width=.525
what's the moog valve
what does mean by kva rating
operation
dear sir i have completed one year post diploma certificate in thermal power engineering from national power training institute durgapur ...plz suggest me for power sector job
some one can tell me how residual type excitation is provided through transformers to an AC generator without any battery or PMG&excitor
How do you consider that you can improve and what assistance do you need to achieve this
why is the in steam turbine axial displacement of active side thrust pad is positive and non active side thrust pad is negative.
why airtel use + 24 volts and other operators use -48 volt
im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much
What is LB-SR.
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
How to calculate power press toneage