what is the weight of 8mm dia steel with 1 meter length.
Is there any formula to calculate the weight for any given
diameter
- 48 Answers
- 322250 Views
- Benny Industries, D M Systems, L&T, MYC Infra, OL, PWD, Shell, SMB, SODI, Spyro Engineers, TNS, Welspun, I also Faced
- E-Mail Answers
Answer Posted / sowmya c k gowda
Formula, Weight of steel in kg/m={(D^2)/162}*L
=((8^2)/162}*1
=0.395 kg/m
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
how to calculate detail quantity of bricks and mortar for 500 cu.ft masonry work. consider wall thickness 9 inches
Slump Values for works?
What is the density of 1:1.5 (Cement:sand) ratio in plaster? And Conversion in 12.5 mm thickness per square meter? Howmany Kg of Cement square meter in ratio of 1:1.5?
What is the cost of shuttering per Sqm.? How it is calculate by thumb rule...?
How to calculate quanty of steel in four leg stirrups?
Consumption of Binding wire for fixing of cover block in vertical surface
cause of cylinder test failure
4. Differentiate between NC and OC soils. Draw curves for (i) Stress vs Strain (ii) Volume charge vs Strain (iii) Pore pressure vs Strain for these soils
In cement making,what is meaning of blend,fineness,density.
In cement concrete how to check a quality of material also proportion of material at site ?
Design a built-up column carrying an axial load of 1200 KN. Its length is 8m and it is effectively held in position at both ends and restrained against rotation at one end. Assume yield stress of 250 mpa
how to calculate labour strength for work for RCC,brickwork,blockwork,in &out plaster,flooring,dado,door frame & shutter,painting etc for constructing highrise building?
Providing and casting in situ cement concrete M-25 of trap/granite/quartzite/gneiss metal for rcc, Providing formwork,Curing the concrete and Complete. what is rate per Cum. and what is rate for M-30 Grade Concrete.
what is the types of door's wood?
in staad pro. modelling for a parallel scissors chord truss, when i assigned roller support i.e fixwd but with all Fx, FZ, Mx, My and Mz release except Fy... the analysis results " in stability at a joint, with direction Mx or My..what could be the reason...anyone please explaing
