Interested to Buy Any Domain ? << Click Here >> for more details...
What is surging in centrifugal compressor. how its happened
and how to avoid it.?
- 10 Answers
- 39602 Views
- I also Faced
- E-Mail Answers
Answer Posted / ahmed zaky
Surge occurs at the lower extreme of the compressor flow
range where the gradient of a compressor’s pressure
characteristic becomes positive; therefore any reduction
in mass flow rate will result in a reduction in the outlet
pressure from the compressor accompanied by a reversal of
the high pressure flow downstream of the compressor.
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
Wasco Interview 1-the type of transducer that convert mechanical movement into a voltage 2-pump 2500 psi and 100 MG select it 3-modes of heat transfer 4-the difference bet PSIA and PSIG 5-the function of relief valve and no return valve (check valve ) 6-types of bearing general catogires 7-function of bearing 8-compressor surge 9-pump cavitation 10-define critical speed 11-compression ratio decease volumetric ratio ........... 12-using inter-cooling in multi stage compressors to ....... 13-using cascade system in refrigerator function ? 14-define performance and efficiency .
Can you give me detail of Diesel Quality parameter in use of DG sets.
Fire Engine should be stopped in auto mode or not. If stopped then why and if not then why not?
How are the pneumatic system and the hydraulic system similar?
Explain the opening and closing of water to the bowl of the purifier
Name the carpentry process?
Can I use IS 2062 GR B Material for low temperature application upto -20 C ?
Explain important rules that must be kept in mind while designing castings?
What is the normal vacuum pressure in a steam turbine atmospheric condenser? What would cause the press to falls?
what is the procedure getting road permit form online
"In boiler, what does steam and smoke goes out to the funnel. What reason?"
How do you define mechanical efficiency in case of compressor? How it is different that of an IC engine?
How can check gear pitch?
When mesuring the flow of liquid what are the two things to measure?
why the wear of back tyre takes place more rapidly than front?
