Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / dinesh chaudhary
mcb is used for less load while mccb is used when the load
capacity increases i.e. for less current ratings we use mcb
& for high current ratings we use mccb
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
plz send me the placement interview question and answers of whizchip(technical and apttitude)..i have an interview in next.
Explain bypass capacitor?
briefly explain principle of resistance welding
ROC converges if poles and zeros lie inside a. Origion b. Z=1
How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
can i use ups power as a raw power for another ups
What Should be the value of Vector Surge angle at Tripping and how to calculate it?
what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?
How do i carry out or know the vector group of a Dyn1 and Dyn5 transformer
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
how we decide the require size is this for a known current at fuu load?
