Answer Posted / dinesh chaudhary
contactor is simply used to make the contacts between two
ckts of low rating while breaker works when relay commands
i.e. relay is used as a sensing device which sense the
abnormal condition & command to the ckt breaker to brek the
ckt.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?
hello friends..... any one have papers or any study materials?sail ,hpcl...?
WHAT IS DEGREE OF COMPOUNDING IN D.C MACHINE MEANS? HOW TO READ THE OPERATING CHART FOR ANY ELECTRICAL MACHINES?
Define resonant frequency?
What are the factor to be consider for CT selection in 132kV substation?
what is the meaning of 0.5ohm Resistance
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
How to know Resistance and Reactance value of main and aux winding of single phase capacitor start capacitor run induction motor to find capacitor value?
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
What are the different types of transformers?
mccb service sittings be done?
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
why 1.7Uo for HV cable Hi pot test?IE standard why?
sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....
How to synchronization will be done between two DGs ?
