Interested to Buy Any Domain ? << Click Here >> for more details...
Dear sir,how should i set the relay in star delta starter..say
ex i am having 4ohp motor,,wht should be the relay setting...?
- 4 Answers
- 5611 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Relay setting shall be done 1/3 times of the full load
rating of the motor.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Can 4pole (3 phase+neautral )RCCB proper functioning in only 3 phase load (no neautral, no Earth) ?
If Neutral Grounding Resistor (GR) failed/shorted. Is it repairable.
What are the types of control system?
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
Describe Non I.S. Earth System and why is it used?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
sir please tel me how calucalte kwh if home taken load 30ams how maney kwh taken per day.and 3phase motor 5hp per hars how maney load teken and how mach kwh and forward me to electrical table for calicalte kwh and kvr and kvah
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
State nyquist stability criterion.
Whata are the types of Cables?
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
1.4 What is meant by CT knee point voltage and how would you determine it
What is the practical way to calculate the cable size for known ampere load?
what is booster? and how it is connected in a circuit?
technically, what is the reason behind starting the motor star the delta connection .. and what other ways to do this rather than using " star-delta transformer"
