Interested to Buy Any Domain ? << Click Here >> for more details...
Dear sir,We have a 7.5hp motor,it was running smoothly and
suddenly one winding is carring more current then
others(r=6.5,y=6.3,b=10)..whts wrong with tis...?
- 5 Answers
- 8303 Views
- Hindustan Motors, I also Faced
- E-Mail Answers
Answer Posted / prasanna kumar
when one of the incoming fse was burnt so that the motor
runs on two phase.so that one phase will draw more current
and the motor gets heated.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What happens if the Capacitive Voltage Transformer Primary neutral is not earthed. There is a CVT between Transformer and source, and the CVT neutral of the transformer is not earthed, does it effect the transformer while charging or does it effect the transformer charging process.
How can we convert 11 kv to 440 volt without using transformer ?
What is the important precuations need tocarried out while working with Electrolite in Battery PM?
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
As we use capacitor bank in 3ph ckt to improve PF, can we use capacitor in single ph domestric use, in house we have Fan,Mixer,electric cooker,iron,tube choke they also lag the system,because it is inductive load. if it is possible to improve PF of single ph system-- if yes- type of capacitor to be used,connection diagram, working in detail. if no-- list it.
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
PLEASE SEND ME NTPC RELATED INFORMATION LIKE WHICH TOPICS HAV MORE SCOPE,BOOKS TO READ,CUT OFF...PLEASE.mail at thiru.1203@gmail.com
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
how to calculate transformer load?
State kirchoff voltage law?
What happens if i apply 500V to 440V rotary Switch ?
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
why asa method ZPF method is more accurate than ASA method?
Why ground terminal is used in pot meter 10k ohms
how many current required for hypo test
