Interested to Buy Any Domain ? << Click Here >> for more details...
Why MS rod or flat are used in stead of GI rod or flat in
switchyard earth mat ?
- 2 Answers
- 11893 Views
- I also Faced
- E-Mail Answers
Answer Posted / manish naha
1.GI strips get corroded at the welded joints more rapidly.
2. Gi. Strips under ground tend to erode MS base due to electrolytic action.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
i am going to attaned the engineer (disign)iterview at HAL please give me duid line
sir iam from electrical and electronics branch ,can i appear for the hpcl offline requirtment? if yes please mail me on vikram_raju25@yahoo.co.in
How much weight an electrical engine can pull??
the typical output of a solar cell is........
What is icu and ics in Acb and how many time icu or ics passes from breaker?
What happens to a line-frequency of high-frequency transformer when it is first energized/ re-energize?
what are the application of over current relay?
What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?
what is the earth current,reverse power,electrical trip generator short circuit,low voltage, high voltage please discribe me
what the principle of sincroscope?how it works?when it needed?
what is mean by parallel operation of permanent magnet generators
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
what is the use of vcb & isolator in substation?
how to calculate energy of 3-phase motor?
