How to calculate the voltage drop of 4 Core 50 Sqmm SWA
cable for a distance of 350 mtrs and what can be the
maximum load connected to it?
Answer Posted / avd
Voltage drop in cable is a function of load current. It is
simply V=IRL. where V= voltage drop in cable, I= Load
current, R = Resistance/meter length, L= length of cable in
meters.
For maximum current carrying capacity of cable please see
menufacturers catalogue.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
why burdens of VTs is more than CTs?
How can calculate the earthing strip of Copper/GI for rating of 30kV,discharge current 10KA Lightning arrester.
What is the difference between Delta & Wye windings?
why various test are performed on electrical panels & power cables before commissioning on site & what are these test???
Dear all, i completed M.E(Power Electronics & Drives) 2011 passed out having 78% so i need job in core side but i don't know how can i receive the calls from electrical companies and i uploaded my CV in naukri, times jobs etc.. In that iam not recieved any mails from good companies so give me best procedure plzzzzzzzzzzzzzzzzzzzzzzzz..... Thanks, K.Linga Reddy Email-id:-lingareddykmthm@gmail.com Ph no:-08015402078
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
What is cut-off rate?
What is the difference between acs 550 & acs 850
what is value of Jin transformer
I have been using an 600VA with 0.6 p.f UPS with my desktop which has 450W power supply unit. Can anyone explain how can this happen . Because the output of the UPS is 360W (600*0.6) (<450W)
11 kV line deraction check by an Engineer.
how unidirectional torque is produced in DC motor?
what is a bus riser in power system and why it is used