Can anybody tell the formula to calculate temparature rise in the cable with respect to current?
Answer Posted / 7anoter4
The temperature rise in a conductor of a cable depends on
lot of factors as-for instance-:
1) The current supply way :continuous, intermittent, short-
time.
2) the cable ambient medium: air[free open, conduit, cable
tray], underground[direct, in conduit or in duct]
3) number of cable and distance between them
4) current frequency d.c.,50 or 60 Hz[ conductor resistance
depends on frequency]
5) other source of heat in vicinity-hot pipes, sunshine or
other.
Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
one conductor length is L.and i am strech uniformly this conductor and made length is 2L.so resistance of this strech conductor is R=4R..but i want to know about area of stech conductor hows it become a/2..
what's the difference between abs/inc encoders. apart from the position remembrance what are all the other differences. and what's mean by grey code.
What will happen if the d.c. Machine is operated below rated speed?
What difference between ref protection and differential protection ?
What is the unit of charge and current?
how to store the thunder power?
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?
What is the restart inhabit setting in ABB spam150c relay (Motor protection relay)
defination of transistor controlled series capacitor
when elecromagnatic waves are propogated in a wave guide?
what is motor capacity of 80TR chiller? and also say what is the formula related temperature, motor capacity, TR?
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
If short circuit ratio is high is it bad or good for a machine then tell the reason...
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
Mention the methods for starting an induction motor?