If single phase voltage level is 230V than why three phase
voltage level is not 660V ?, but it is only 440V.
- 16 Answers
- 70457 Views
- BSNL, DOS, EFS, HMT, L&T, TCS, ThyssenKrupp, I also Faced
- E-Mail Answers
Answer Posted / pete
The question is incorrect, the line voltage is not 440v, it
will be 400v if your single phase is at 230v.
Reason why its 400v is because if you put a voltmeter across
both live phase voltages, it show 400v. But you will need a
picture showing waveforms to explain it properly.
| Is This Answer Correct ? | 8 Yes | 7 No |
Post New Answer View All Answers
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
why we use single core 630mm2 cable for transformer secondary side
Which Class insulation is prefered for the sandwich Busducts ? Why?
how is the cable tray designed & how its total length is calculated for an Industrial plant Say for Ex. (500KW Motor Load)
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
High speed earth switch operation with diagram
Can we use shunt trip coil instead of trip coil with protection relay for protection?
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
In a single how much maximum current and watts using
how to select fuse rating for a 3-phase motor ???
How does cost of generation from hydropower plant compare with other sources of electricity?
what are the possible reaons & remedies if resistance of NGR getting heat up
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??
How you calculating the 30 Hp 3 phase AC motor of power what size of cable is used for this motor?
