Interested to Buy Any Domain ? << Click Here >> for more details...
What is the Laplenth for Reinforcement for Verticl and
horizontal Structures as per IS code?
- 7 Answers
- 13486 Views
- I also Faced
- E-Mail Answers
Answer Posted / ravibabu bammidi
Dear
Lap length of bar depends on grade of concrete and design bond. so we get different lap lengths for different grade of concretes which are as follows
(Grade of concrete) Tension Compression
M15 56.4d 45.15
M20 47d 37.6d
M25 40.3d 32.25d
M30 3706d 30.1d
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
if dia of slab beam bar is38mm what its clear cover any method of provide clear cover
What is the compressive strength of fly ash bricks?
Method of findingthe dry ingredient quantity of 1 m3 concrete. what is the difference between static and dynamic induced emf? Testing charges bill given for Rs. 32,000/- but not added service tax in this bill. So, How much TDS will be deduct
If specific gravity of cement is less than 3.15 what is the cause?
How much material will consume for following specification water tank (9*7.5*6 feet)?
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
Define Who designed the city of Washington DC?
20 mpa what is the quantity of cement sand and aggregate in one cubic meter of pcc non rainforcement concreate kindly answer including formaula thanks
5. Do you feel that your present employer estimates your full work potential? Are they pleased with your work performance?
What things architect have to take care of before starting any project?
manhole height is 1500 mm and width of brickwork is 230 mm dia of manhole covering is 560 mm brick masonry 1:4 horizontal length is 1500 mm and plaster 12 mm thick on both side 1:3. how to estimate the quantity of brickwork with mortar cement and sand for manhole chamber.
how to preaper for interview wat they asked in interview give me idea
Reinforcement details at hinged joint
What is oneside mat. And explain
What is meant by dimensioning?
