in 8051 microcontroller port0 has no internal pullup why?
Answer Posted / shankar
For the better understanding of PORT 0 and the concept of pull up registers, you can check this video out.
http://www.youtube.com/watch?v=t9bN-2nFNEs
Is This Answer Correct ? | 6 Yes | 8 No |
Post New Answer View All Answers
Define quad?
Explain the Proportionates of Ordinary concrete,Standard concrete,High Stength Concrete of Grades "M10,M15,M20" , "M25,M30,M35,M40,M45,M50,M55" , "M60,M65,M70,M75,M80" Respectively.
interface an 8-pin switch with 8085 microprocessor located at 0AAH and LEDs at port 55H, draw the circuit diagram. Write down a program to read the switches and do the following: > if the parity of the switch is odd, start counting upward until it reaches 0FFH. > if the parity of the switch is even, start counting downwards until it reaches 00H.
Define setup time?
Explain what is difference between fixed-bias circuit & self-bias circuit?
what is a bleeder resistor?
What are the applications of precision diode.
How is cad used with electronics? Give example.
When a sample of germanium and silicon having same impurity density are kept at room temperature then resistivity of silicon will be higher than that of germanium, why?
What is meant by pwm control?
Define what is tunnel diode?
What is meant by pmdc?
What is negative frequency?
why interrupt is necessary in microprocessor?
Explain how to format a memory card by using memory card?