Interested to Buy Any Domain ? << Click Here >> for more details...
why the carbon brushes are used heat created rotating parts in
eiectricity
- 1 Answers
- 3560 Views
- I also Faced
- E-Mail Answers
Answer Posted / bala
carbon is a NTC(negative temp coefficient)material. its
resistance decrease while temp gets rise. also carbon gives
wear for give smooth rotation without friction. so its used to
give smooth rotation and less resistance in electricity..!
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
description with working of all parts of a Diesel generator???????
I need bhel previous year quetion papers for electrical engineering department.I searched but i could not find out
How we can calculate the Amps for the cable Ex:- For 1sqmm wire how many amps we can draw (calculation)
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
if we have 320KVA Genset kindly advice how much load we can put it.
What is a signal flow graph?
I have finish diploma electronics and five years experience in electrical field in ht service how can i get c licensce or other electrical certificate
What are the difference between normal application Transformer and Solar application Transformer?
what is meant by impulse voltage?
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
Define pole pitch?
what is thresold of perception
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
what is the function of gss in the dg set.
