why circuit breaker closing time is always higher then
tripping / opening time.
- 13 Answers
- 43094 Views
- United Phosphorus, I also Faced
- E-Mail Answers
Answer Posted / thayathidavan gopalan
Closing time is always greater than opening time.Closing a
breaker means you have to close against the inertia and it
is closing on no load normally.
Opening time should be fast as possible to interrupt the arc
fast to avoid damaging of the contact , It depends upon
the manufacture and design of driving mechanism ,make to
open as fast as possible.
opening during fault shall be as fast as good to maintain
system stability also
| Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
Why to keep capacitor bank off while generator running.
If i have two 3000 kW motors and the whole facility requires a 10 MVA transformer. What would be better installing two 5 MVA transformers(one for 1 motor ) or just a single 10 MVA transformer for both of them. Give reasons for your answer.
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
working principle a.v.r. ?
Why we are using Isolation Power Transformer inplace of commercial power transformer? What's the difference between them?
why the rotor current becomes in steady state during high slip region? please verify with equations.
can any tell me why slope 40% and 80% is calculated in differential protection?
What is the previous name of Cox's Bazar
why ht motors are star connected?
what is the difference between electrical choke and electronic choke?
Explain the experiment on ward leonard method of a speed control on a dc shunt motor with an suitable circuit diagram.
how can you calculate fault level ?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
Which type of motor is used in trains, what is the rating of supply used explain working principal?
What is cable tray, its type, and its support?
