Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / devsingh boda
ANS1,ANS3,ANS4 are correct.ie,
We can answer this question in two ways,
1.Capacitive reactance is inversely proportional to frequency since,Xc=[1/(2*Pi*f*C)] which implies Xc is inversely proportional to f. For dc f=0 , so Xc is approximately equal to infinite(very high).So current does not flow.
2.We know that capacitive current, Ic=C*[dVc/dt]...
If dc supply is applied across capacitor then dVc/dt becomes zero since dc voltage is a constant(steady) voltage.So Ic also becomes zero.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
What is capacitance?
what is the safety of voltage power transformer(2250KVA0
why they were using TRIAC instead relay in some controllers and what is the advantages.
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
Explain RLC circuit?
why we are not giving the zone 1 trip command to the master trip relay
what & how to check the lightning arrester
What is the gross weight to copper ratio in slip ring induction motor of 4000 HP,6.6 kv, 372amp, 992 rpm GE motor.
induction 3 phase motor terminal connection
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
what is lumped and distributed elements?
