Interested to Buy Any Domain ? << Click Here >> for more details...
If in a 3 phase supply if the load current is 200A what
value of current the each phase R,Y & B will carry?
- 5 Answers
- 7906 Views
- I also Faced
- E-Mail Answers
Answer Posted / jaibir kadian
if phase current are balance than it is 200/3 each phase. if unbalanced than remaining current goes through neutral.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
what is the string efficiency
what is difference between elr and R eartl realy.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is inrush current?
how we find transformer capacity by ohm
what is meant by skew width in machines?
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
SIR, GIVE ME OPGW SAG CALCULATION FORMULA I AM DAE ELECTRICAL. THANKS
how to calculate power consumption in slip ring motor at different step
What are the main significances of root locus?
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
What is the role of feedback in a closed loop control system?
what is ic 01,ic 06 ?is it types of cooling?
If oil and air can withstand a high MeV when used as an insulator in a transformer, what are the values of how high for each material?
State how to produce a constant rotating field by application of alternating currents to stator armature of a three-phase squirrel-cage induction motor
