Interested to Buy Any Domain ? << Click Here >> for more details...
please explain about actuator action?
direct action & return action ?
- 1 Answers
- 4596 Views
- I also Faced
- E-Mail Answers
Answer Posted / raju
based on air connection on diaphragm,spring force
direction,positioner o/p
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
Which products are available in the Mass Systemswitch and System Manager AC range?
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
How many are the types of instrument cables in terms of No. of pair.
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
State some of balance principle’ advantages?
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
What is the main difference between Cavitation and Flashing?
1.can you use SCADA instead of DCS,DCS instead SCADA 2.Difference between DCS and PLC,can their role be reversed i.e. role interchange 3.Difference between RTU and PLC
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
