Interested to Buy Any Domain ? << Click Here >> for more details...
In case of 11kV dual delta bank what are the recommended
protections with specific CT / VT requirements? The
capacitor bank is to be connected to the main 11kV
switchgear from where the H.V.Motors and auxiliary 440V
loads.
- 1 Answers
- 3069 Views
- I also Faced
- E-Mail Answers
Answer Posted / rkarthieee3
over current,over VOLTAGE
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is bode plot?
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
why servomotor motor? where i apply for best output?
how to calculate cable size in diffrent loads?
I NEED RRB SYLABUS FOR JE ELECTRICAL ,PLEASE SEND TO MY E- MAIL ID joo28_eee@yahoo.co.in
How to find ampere on ht side for selection of cable size ???
block diagram of 2 ups system connected in hot stand by mode?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
What are the advantages of stationary armature and rotating field system?
What happens if we run alternator on under frequency?
What is grid collapse? what is the reason for it?
What is the power factor of an alternator at no load?
How Can You Relate Power Engineering With Electrical Engineering?
My question is abt backlog.I had dropped one subject in my second year, and completed this subject in the 3rd attempt, so how many backlogs i have got?1 or 3?plz sujjest the answer as soon as possible
