Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / pragash b
Yes possible... provided Bearing is capable of taking axial loads
| Is This Answer Correct ? | 23 Yes | 0 No |
Post New Answer View All Answers
What are hydraulic and pneumatic machines?
Distinguish between the shear center and elastic center.
What happens when too much cylinder oil is injected in the working cylinder?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
Explain how do motion detectors work?
Where pneumatic system is used?
what is sight glass, water level meter, water level indicator, level control probe?
What is forced convection?
What is shearing?
What is the formula for 1 HP of a two-cycle engine?
Define pitting.
What are the causes if one cylinder in a diesel engine has a high temperature?
What is the thermal efficiency of a diesel engine?
Study the attached ACS 790 AHU and boiler GUI and refer to the video on the software usage, catalog and the step by step document (page 9) to perform the following task: List in a table form the controllers and all their connected I/O for the boiler and the AHU.
What is the indication of leaking starting valve of an engine?
