Interested to Buy Any Domain ? << Click Here >> for more details...
what happens when dc supply is given to the transformer?
- 3 Answers
- 5653 Views
- I also Faced
- E-Mail Answers
Answer Posted / sudhakar g
If we Dc supply to primary side of the transformer means
the Flux doesn't change and it causes the winding of the
Transformer will burn....
| Is This Answer Correct ? | 24 Yes | 3 No |
Post New Answer View All Answers
how to find the multiplication factor for digital energy meter and analog energy meter
what is the use of piston rings in the engine used for a generator...........
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
Define de-sensitivity?
State ohm’s law?
WHAT IS DEAD END IN PROTECTION?
What is error of a measurement?
Factory acceptance test. FAT. For 132 kv transmisstion towers what is that meaning and what are the tests commonly companies perform now days.
how do we calculate length of starting time and repeated starting of a direct online starter?
How will A Medium voltage circuit breaker(11 kV voltage level) operate under short circuit fault condition whether It is having short circuit release like Low voltage circuit breaker or relay should be given?
When steam condenses and becomes water at the same temperature, the specific heat for the process in kJ/kg k is
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
What is the use of lag compensator?
we are small scale industry in production of rice & rice bran. Pls let me know how to take contract demand for our industry.. (for information we have total 600.hp)
what is earth pit , how we can measured it, what earth rods reference
