Interested to Buy Any Domain ? << Click Here >> for more details...
why? Boiler furnesh pressure transmitter mount in boiler top and it's impulse line is in bottom of the boiler. Aneybody kindly tell me this reason.
- 1 Answers
- 5060 Views
- Birla, I also Faced
- E-Mail Answers
Answer Posted / ahmed helmy
to avoid the direct contact of hot steam with the transmitter so the impulse line should be filled with water which is coming from the condensation in the below of the boiler.
| Is This Answer Correct ? | 6 Yes | 5 No |
Post New Answer View All Answers
how to relay switch sense the fault?
what is the electrical operation procedure for switching on 27.6MVA electric furnace.
What you mean by multi stage control vavles?
can we create an interrupt in plc through scada?
What are the types of control valves available
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
Operational amplifiers
Lux meter is the measuring device to measure the lux level of lighting fixture. in industrial sector two types of lighting fixture is being used as street lighting purpose 1. HPSV (Sodium) and 2. HPMV (Mercury). HPMV having white light which is an combination of red, blue and yellow colour, while HPSV haivng Yellow lighting. in HPSV red & blue colour will be absent. during measurement of the lux level of HPSV and HPMV fixture. 1. Lux meter can measure the actual lux level of both fixture? 2. or it will show false reading for HPSV fixture light as it has only yellow light present. please give me answer
what is diffrance between FF & SMART, explain with difination
Explain the working of an enraf level gauge.
what is the process for double acting cylinder pneumatic for 32' v/v
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
Programmable Logic control.
WHAT IS TMXT IN TEMPERATURE FOUNDATION FIELDBUS.
