Interested to Buy Any Domain ? << Click Here >> for more details...
How can measure flow in oil line?which type of transmitter
is generally used?
- 1 Answers
- 4118 Views
- I also Faced
- E-Mail Answers
Answer Posted / karthikeyan
concept:flow is directly proportional to the square root
of differential pressure. You can use differential pressure
transmitter with orifice plate,orifice plate is used for
create DP in oil flow line.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Draw block digram for well head from well to shipping pump?
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
How d.p. Transmitter can be applied to open tank?
Why do we floating DC in DC system.
Explain the use of hair spring in the pressure gauge.
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
State some of balance principle’ advantages?
what is zero and span ?
Hook up resistance decade box to temp.transmitter.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Emergency Shutdown Systems/ Plant Shutdown System.
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
Please can anybody help for control valve sizing step by step procedure?
