Interested to Buy Any Domain ? << Click Here >> for more details...
HOW TO IDENTIFY THE RELAYS WHICH APPLICATION IN WHICH RELAY
USING
- 3 Answers
- 6638 Views
- I also Faced
- E-Mail Answers
Answer Posted / rasi
NO#1 IS CORRECT.BUT ALSO,OVER CURRENT&EARTH FAULT
PROTECTION ARE USING ALL RELAYS(TRAFO,FEEDER,ETC).AND REF
PROTECTION USING IN TRANSFORMER
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
While testing a ZCT what parameters have to check or measure?
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
What is Surge Capacitor? Why it is use in Generator Circuit Breaker?
working function importance of mdc meter
How does a television work?
What are the functions of different probes used in cro?
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
Ceiling Fan and Storage type water heater. Discuss
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
HOW can i REuse the fused MLL LAMPS & GLS LAMPS at our factory
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
