Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / chandan pandey , ballia
when voltage is apply in the ckt
we know voltage is a type of
electric pressure which press
electrons in the ckt in opposite
direction of flow of free electrons
current will be flow .
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I have a CT meter with ratio 60/5. The meter reading of previous month was 3290.49 and that of current month was 3797.26. How many chargeable units as per normal meter should be my reading.
what is the difference between capacitive and resistive voltage divider?
Why is voltage is required to be within permissible range for an electrical equipment?
We need to current density & short circuit calculation at 65kA for aluminium & copper busbar.
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
can any one tell in easy method for circulating current ??
What is the estimated total hydropower potential of india?
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
Tell me the reason of connecting domestic t/f primary in star or delta,and also secondary side.
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
how we can set the IDMT relay.
What are the two major types of control system?
orifice sizing how done, checking & selection
At full load wat is the motor p.f And at no load will is the motor p.f?
