Answer Posted / dr.reddys corp sup
starter:it's produce starting high voltage.heated up
electrodes emision of electrons
choke:it"s used starting current is reduced under tube
running condition.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the difference between a verilog task and verilog function?
what is the eight bit unit?
why in an industry; machine having rated 200 h.p stopped after power factor is maintained above 0.97 lag by control panel in view-of energy saving
what is dry and wet frequency withstand voltage? why & where it is used??
why the rotor current becomes in steady state during high slip region? please verify with equations.
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
What is meant by RVT and NDR ? expansion and details of it
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
What is the purpose of stablization resistor in high impedance bus bar protection
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
How relay works, reverse relay, master relay, os relay, earth fault relay and what is its setting point
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
Is electro plating what type of load whether resistive, inductive or capacitive loads
What is the meaning of utility ground and clean ground? How the distribution panel is grounded?
