Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mugil
piezo electric transducer is a device that use the" piezo
electric effect"to measure pressure,acceleration,strain or
force by converting to an electrical charge.
piezo electric effect principle:one rays is pass through
the piezo electric crystal it is produceed voltage.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
What is the procedure of calibration of Load cell?
Conversions
what is the input to be given in digital flow meter during the the calibration time?
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
What is standard procedure of manual mapping in Radar type level transmitter?
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
How to Calibrate Radar Level Transmitter in Field
Can anybody tell me how to select the size of earthing cable for DCS & PLC system.Please tell me any relevant answer here or mail it to me.
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
what is interface level and how it is calibrate?
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
