what type of oil is used in transformers? a)conduting b)
insulating
Answer Posted / nissan patel gujarat
Insulating oil in an electrical power transformer is commonly known as Transformer Oil. It is normally obtained by fractional distillation and subsequent treatment of crude petroleum. That is why this oil is also known as Mineral Insulating Oil. Transformer Oil serves mainly tow purposes one it is liquid insulation in electrical power transformer and two it dissipates heat of the transformer e.i. acts as coolant. In addition to these, this oil serves other two purposes, it helps to preserve the core and winding as these are fully immersed inside oil and another important purpose of this oil is, it prevents direct contact of atmospheric oxygen with cellulose made paper insulation of windings, which is susceptible to oxidation.
Generally there are two types of Transformer Oil used in transformer,
1. Paraffin based Transformer Oil
2. Naphtha based Transformer Oil
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is a feedback in control system?
how the inner and outer body is separated in aircrafts?
Write the force balance equation of ideal spring element.
Why 3 phase induction motor getting supply in body if one of it's phase is cut
What is the difference between line drop and percentage line drop?
Explain the different methods used in the choice of rotor slots for reduction of harmonic torques in an induction motor.
should %impedance be high or low in a power transformer? if so why?
Draw torque - speed curve and load curve of induction motor? mark operating point ?
How is operate breaker failure scheme in substation
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
Usually in the L & T make MCC feeders' power circuit,we have BMR after the MAIN CONTACTOR.,can we interchange their position, keeping the control logic same???
How can you sized or estimate the ligthning arrester current rating?
Name one of major transformer company in KSA ?
How do I calculate a WTI CT ofa 1250kVA 6600/400V transformer
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?