Interested to Buy Any Domain ? << Click Here >> for more details...
In control valve , Failure position : Close
If it is Fail close(FC) during failure of AIR.. what will be the initial/ normal position of control valve is it normally open or close? please some one explain soon..
- 2 Answers
- 11281 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajesh.kon
need answer ASAP
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies
is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?
How to calibrate Magnetic flow Transmitter in Field
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
What are the uses of orifice plates?
In turbine what does term CDP, NI, NH, HSSOC means.
which type inter lock use in petrochemical refinery,and oil & gas?
how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
How ejector(or)evactor air pump is working in thermal power plant?
