Interested to Buy Any Domain ? << Click Here >> for more details...
What is mean CT Saturation? How to calculate?
- 13 Answers
- 113123 Views
- NCC, I also Faced
- E-Mail Answers
Answer Posted / elec engg
#9 and #10 are absolutely confused :D
Secondary in a CT usually has a very High voltage (Primary= 1 Turn; Secondary= Many many Turns).
That`s why, if u leave Secondary open when the CT is Offline, a large voltage build up on the open Secondary causes a failure of its Insulation on Secondary, and renders the CT unoperational/BLOWN !!
| Is This Answer Correct ? | 2 Yes | 9 No |
Post New Answer View All Answers
transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
what is mean by drives?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
how to calculate maximum current
Why there are some equipment(i.e:TV) that using 2-pin plug instead of three? What happen if there is current leakage? Are we going to get electric shock??
block diagram of 2 ups system connected in hot stand by mode?
what is metering cum synchronizing panel and how it is used?
in star-delta tranformer,if the input of star connection is 400/7v 3 kva then what is the output of delta connection?
Define conversion efficiency of a power amplifier.
Is it possible to connect a safety device in to parallel?
how to measure the current by compact digital equipment with dislay which fit inside any equipment
How calculated single phase induction motor req. Capacitor?
Explain forward resistance, static resistance and dynamic resistance of a pn junction diode.
