Name some of the common protocol use in automation.
Answer Posted / karthik
MODBUS TCP/IP
MODBUS RTU
Profibus DP
Profibus PA
Profisafe
HART
Foundation Fieldbus
DH (AB)
MPI (Siemens)
PPI (Siemens)
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
If P will increase then what will happen with PID?
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
Somebody tell me in what way i need to prepare for csio pgrpe(adv instrum eng)interview?what all the quest can i expect?
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
How many ohms are required for proper earthing?
Explain the burnout feature.
Please can anybody help for control valve sizing step by step procedure?
I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).
What is solenoid valve? Where it is used?
what is wave length were using ?
If we increase only P what will be controller action ?
which type inter lock use in petrochemical refinery,and oil & gas?
what is the calibration procedure for transweigh make weigh feeder?