Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / shahabz shaikh
as p.f is high then motor drawn more current from supply and
load is increases
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
How can we calculate the motor frame sizes?
What is power in wattage of 8.5 TR AC
With a phasor diagram show the effect of increasing the field current of a generator supplying a constant real power and connected to a grid system.
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
what is physical distance of isolator to VCB in 33/11kv sub stations
how to calculate cable size in diffrent loads?
i have 500 amp inductive load of motors ,,,pleas tell me how can i calculate for capacitor bank for improving my power factor to 99 .....calcullations for capacitor bank,,,,
how many joint can done in HT line and what is life of the joint
Do u know any one? how to find out in motor rated amps? formula?
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
what is the use of expulsition protective gap in 11Kv line.
What is inverse definite minimum time lag relay? Where is it use?
