what is cogging and crawling
Answer Posted / naga gopi
the no of stator&rotor slots are equal in quantity,then the
flux producing each are same so the rotor&stator are runs
with same speed after little some time motor stops rotating
that means motor is stops automatically.they are locking
each other then it will be refused to run. this is
cogging/teeth locking.
the rotor rotates below the sy.speed,i.e (one seventh speed
of sy.speed),this effect cause by the harmonics).this cause
by 3rd harmonic,this is crawling
Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
What information we need to prepare relay coordination chart
how much GROUND & NEUTRAL VOLT maintain in data center.
Dg pf .71 i am improve pf 0.80 what capacitor connected in dg how?
What is the different types of cable & current capacity of cable
Ratings of power transformer,Distribution transformer.
why and how voltage sharing in transformer, during magnetic balance test ?
What is principle of Floroscent tube 36watt.
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
briefly explain principle of resistance welding
if we install two earth pits with a clear space of 5m without any interconnection,by checking the digital multimeter will it show continuity between earth pits? If so what would be the approx. value
how wecalculate breaking capcity of acb mcb mccb .explain with example
what is power factor ? how we can calculate the low power factor and amount of capacitor for improve that low factor ?
what is is the potential diffrence between two phase ?
what type questions asked in hp cl
How to calculate earth wire load by formula