how many cubic feet in one unit of sand?
- 16 Answers
- 174980 Views
- L&T, PSPCL, Ratna Infrastructure Projects, I also Faced
- E-Mail Answers
Answer Posted / subhash
100 cubic foot sand is one unit of sand
| Is This Answer Correct ? | 233 Yes | 53 No |
Post New Answer View All Answers
Dear Sir I Mahesh C. Bhamre have already given a Exam for Superintendent Officer / Public relation Officer Exam Dharmday Aaukta held at Nashik on Date 29/08/2010. My seat no was 5040247. and my cell no is 9822677994. and my mail Id is - mahesh.bhamre@rediffmail.com So can you pl send me details of result of respective exams. Thanking you in Anticipation.
How to come 1.54 from dry to wet concrete?
what is polity
how to take concrete quantity for precast segment for viaduct project?
In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.
What is eccentricity in laymans term Can't understand bookish language .please explain in easy way.
is there any influence of water(used for mixing of concrete) on a weight of harndend concrete.
How to estabilish reinforcement Steel rolling margin for a building projects ?
column at edge of a framed structure is uniaxial or biaxial. and is an interior column is biaxial
for pretensioning which will yield first and same for post tensioning?
how do we design mix ratio?
for 200 kg of cement how is the mix proportion in kg for m25 grade of concrete
For the construction project what capital cost has to be taken in consideration?
I used Etabs software to analyse a high-rise building. And I want to use templated UBC-codes inside to calculate the Seismic load. My question is: whether or not I have to control the seismic load by base shear load which is manual calculation? (just for more clarification: I can control this by input the scale factor into Eartquake definition in Etabs) I would highly appreciate your answer.
if in column reinforcement lower dia connect to higher dia then from wher we want to start higher dia steel
