Interested to Buy Any Domain ? << Click Here >> for more details...
WHY HOLDING CONTACTOR OF MOTOR STARTER IS CALLED NO VOLT
COIL.
- 3 Answers
- 20135 Views
- I also Faced
- E-Mail Answers
Answer Posted / jerald xavier
In Motor Starter circuit, The load (Motor) is Normally Open
untill the voltage coil is energised. The working of this
coil is mainly dependent on the voltage, and there is no
importence for current in this coil,hence the name NO
voltage coil.
'N' stands for Normaly, 'O' stands for Open
| Is This Answer Correct ? | 12 Yes | 2 No |
Post New Answer View All Answers
pre arcing time of ehv breaker
During Starter Panel Com missing I Found The Main Incomer 40Amp MCB 10KA Trip When Motor Change Star To Delta Motor Rating 20HP BUT When We Use Same MCB To Other Motor It Does Not trip Or What Is Necessaries for Star Delta Starter MCB SFU MPCB OR MCCB And What are The Breaking Capacity of MCCB in the Motor above 15HP
We have 110Vac ,10A ac supply which is converted into 110VDC & How much DC current? which factor is reqired for dc current calulation?
Post possible questions for Power Factor Panel FAT / SAT
How equivalent impedance is calculated in thevenin theorem?
what is the earth current,reverse power,electrical trip generator short circuit,low voltage, high voltage please discribe me
What are chief characteristics of state-space method and its techniques ?
What is online and offline ups? how does it works?
how to calculate percentage impedence at 75 deg C at normal tap
I have c license but I don't know eligibility of Max Kilo Volts under the electrical licensing board.
Differentiate between ideal and non-ideal voltage sources?
what are your career plans upon completion of the programme and the relevance of recity generation to your professional development?
How to calculate that clean water supply in one Day from 150 KLD STP?
Why in ESP Positive earthed
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
