Interested to Buy Any Domain ? << Click Here >> for more details...
How do you calculate the surface area of the paver blocks,
in oreder to find out the compressive strength of the
same ?? And which codes are used for testing of paver
blocks ?
- 1 Answers
- 12614 Views
- BP Sangle Constructions, ECMAS, I also Faced
- E-Mail Answers
Answer Posted / riaz
The calculation shall be done on contact surface only where the load is applied
| Is This Answer Correct ? | 16 Yes | 12 No |
Post New Answer View All Answers
When column of building is abutting the boundary line,then suitable footing advised is
How do You Maintain a structure after getting cube test of low strength.
design the irrigation canal(b,B,h )head is 3tms of water is supplied to the 200hectars of area and the base period crop is 150days dance to water travels as 35km.the canal section is trapezoidal and also calculate the slop the canal
Explain the advantages and disadvantages of using plastic and timber fenders?
how do i remedy a foundatiom that the column bases was cast and aftet 28days crushing the conprehensive strength of the concrete fall below the specification 25N/mm2
What is the mix propotion of M10,M15,M20,M25,M30,M40,M50.M60 cement content,aggrigate,sand and water ratio.
How can we convert weight batch to volume batch for m30 mix
What are the phases inspections are done by local authority while construction?
WHAT GOAL DO YOU HAVE IN YOUR CARRIER?
What is the yield of 100 litres of water and 10 kg of cement in grout mix?
beam length 73 feet 4 inch,width 01 feet,height 50 inch so every beam load how much? and what quantity of M.S ROD? both side ony two column in middle no column.pls inform me that this is stable or not ? and how much risk of this beam?
What is meant by dimensioning?
How do we calculate the power of centrifugal pump?
how to caliculate required amount of cement and sand required for 1cu.m.
1.what type of the rock is most suitable for wet mix macadam in construction of road? 2.what is the highest maximum dry density and optimum moisture content can be acheive by using most suitable crush rock?
