Interested to Buy Any Domain ? << Click Here >> for more details...
what is total power generation in tamilnadu
What are the methods used powerfactor improved?
which place DC transmission line usde?
- 5 Answers
- 12076 Views
- I also Faced
- E-Mail Answers
Answer Posted / senthil kumar
Nlc,solar,wind ,tide.
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
what is upper impedance and lower impedance of a distance relay
In parallel operation time both NGR’s close or not close if both close what will happen
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
How to confirm the Phase shifting Transformer VECTOR GROUP relation , as below ZNy11.45d10.45-ZNYy0.15d11.15
In cable sizing calculation (determining the max route length of cable) why we choose the shortest length between cable length of full load current Iflc & starting current Istart?
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
Explain what is rated speed?
How is the gain affected by the introduction of feedback in a control system.
What are the advantages and disadvantages of the dc motors?
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
DESCRIBE THE CONSTRUCTION ANDOPERATION OF BELT CONVEYORS AND SCR CONVEYORS , DRAW NEAT SKETCHES
Define resonant frequency?
Why mostly the HV side of transformer has Delta?
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?
