what happened if the diameter of capillary tube is double
then the capillary rise will be
Answer Posted / manjunatha
Decreased by half
Is This Answer Correct ? | 13 Yes | 0 No |
Post New Answer View All Answers
What are the standard plastic limit/liquid limit/plasticityindex for differrent type of soils?
3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.
if dia of slab beam bar is38mm what its clear cover any method of provide clear cover
What is the Systematic Responsibility Site Engineer? Who are the above and under co-oridinating ? What is office & Site co-ordination of Site Engineer?
how do you calculate the quantity of steel,cement for plinth beam. (example size 41'*0.58'*1.08')
dialation means
what is Short bored pile foundation.
WHAT WII BE THE WATER ABSORPTION POWER OF WOOD ?
what is meaning of inverted beam.is it way to provide double mat in slab one at bottom and another at topif we go for provision of inverted beam. shall we construct structure with out plinth beam for us we have to construct small bus shelter
What is OSHA compliance?
01. a. Diagram of a slump cone…………… 1 b. Size of Slump Cone…………… 1 c. Volume of a slump cone by av. Dia method…………… 1 d. Volume of a slump cone by av. area method…………… 1 e. Volume of a slump cone by frustrum method …………… 1 f. Angles of slump cone …………… 1 g. Slump measured by slump cone due to…………… 1 h. Slump does not measured by cylinder / cube due to …………… 1 i) ii) i. Slump cone is to be filled in……………………..Layers.
The building has 12 columns of 12x9 in 3 rows of 4 each in a plot of 50'x30', The central row is strengthened with 16mm twisted rods. The roof area is 1500 sft including balconies. calculate the load factor per sft. Also indicate the number of roofs the building can withstand.
why are you joining in this (applied post) job and your aim for this job
Why M15 is replaced by M20 when ammendment are made in IS456 in 2000?
how to compute slab reinforcements on step by step procedures??